Linux USB

Set bootable flag on USB drive

First you need to partition your USB drive using fdisk then set a bootable flag:

$ sudo fdisk /dev/sdb             #/dev device needs to be a hard drive(sdb) not a partition(sdb1)
Command (m for help): a
Partition number (1-4): 1
Command (m for help): w
The partition table has been altered!

Calling ioctl() to re-read partition table.
Syncing disks.

$ sudo fdisk -l                                                                   
<--- output omitted ----->
Disk /dev/sdb: 2002 MB, 2002747392 bytes
255 heads, 63 sectors/track, 243 cylinders, total 3911616 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk identifier: 0x00000000

   Device Boot      Start         End      Blocks   Id  System
/dev/sdb1   *          63     3911615     1955776+   c  W95 FAT32 (LBA)

Create filesystem on USB stick

You should mark a partition in fdisk as FAT16 (type 0E) if the size is up to 2GB or FAT32 (type 0C) if bigger or needs long filenames support.

df -h                              #find your usb device
lsblk                              #another way to find your device
umount /dev/sdb1
mkfs.vfat /dev/sdb1                     #create fat32
mkfs.ext3 /dev/sdb1                     #create ext3
mkfs.msdos -F 32 -n FREEDOS /dev/sdb1   #format device to fat16, use -F 16 for fat16
mkdosfs -F 32 -n FREEDOS -I /dev/sdb1   #format device to fat32, use -F 16 for fat16, -n partition label

Make bootable USB from .iso image

Copy image to USB

DD can copy a whole image to the desired device but only a hybrid ISOs image will boot.

sudo umount /dev/sdb
sudo dd if=image.iso of=/dev/sdb        #output file of= needs pointing to USB drive not a partition (eg .sdb1)
sync                                          #forces changed blocks to disk, updates the super block and flushes file system buffers

Convert .iso to hybrid image

Starting in version 3.72, ISOLINUX supports a "hybrid mode" which can be booted from either CD-ROM or from a device which BIOS considers a hard disk or ZIP disk, e.g. a USB key or similar. Hybrid images are special as in addition to the normal CD-based ISO9660 filesystem, they also contain a valid-looking DOS-style partition table. The isohybrid contains MBR code which has to match the version of the ISOLINUX file isolinux.bin. Therefore always use the program from the same SYSLINUX installation which .iso has been created by mkisofs, genisoimage, or xorriso and then treat it by:

apt-cache pkgnames syslinux | grep -A 1  Version         #check isolinux version
isohybrid isolinuximage.iso                              #convert to hybrid image

The above operation will append necessary information to the image file thus the file check-sum will change.

Mount .iso

If you have .iso image and want to access its file system you can simply mount it. This is equivalent Windows virtual CD.

sudo mkdir /mnt/isoimage                                     #create mounting point
sudo mount -o loop,ro -t iso9660 image.iso /mnt/isoimage/       #-o options, loop -loop,ro device /dev/loop in read-only mode, -t type eg. ntfs, vfat

Resources

• Isohybrid Wiki