Cisco handy configs

Copy files to Cisco device

ip tftp source-interface GigabitEthernet0/1 '<-- set source tftp interface'
conf t
 #copy tftp flash
 Address or name of remote host []? 192.168.100.11
 Source filename []? 8790_k2_0_7_19.tar
 Destination filename [8790_k2_0_7_19.tar]?
 Accessing tftp://192.168.100.11/8790_k2_0_7_19.tar...
 Loading 8790_k2_0_7_19.tar from 192.168.100.11 (via GigabitEthernet0/1):    !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
 [OK - 16844800 bytes]
 
 16844800 bytes copied in 36.452 secs (462109 bytes/sec)

Upgrade modem Firmware

Cisco Reference process guide Once FW file has been copied onto flash memory, please follow as below: Make sure that modem FW file is on flash memory

sh flash0: | inc 8790
240   16844800 Aug 29 2013 12:55:56 +00:00 8790_k2_0_7_19.tar

Extract archive onto flash

#archive tar /xtract flash0:8790_k2_0_7_19.tar flash0:
 extracting FWUpgradeConfigFile.txt (151 bytes)
 extracting K2.0.7.18bt.cwe (619976 bytes)
 extracting K2.0.7.19ap.cwe (16214913 bytes)

Initiates the firmware upgrade process. Syntax is microcode reload cellular pa-bay slot gsm modem-provision pa-bay — Use 0 for HWIC, slot — slot number where the HWIC is plugged in. Use command below for Cisco Router 1941 with EHWIC card in slot 0.

microcode reload cellular 0 0 gsm modem-provision