Difference between revisions of "Cisco 1941 with EHWIC-VA-DSL-M"
Jump to navigation
Jump to search
Line 40: | Line 40: | ||
|Normal operation. | |Normal operation. | ||
|} | |} | ||
== Config prep == | |||
! clean start by removing current config | |||
erase startup-config | |||
reload | |||
Current platform info at the boot | |||
Cisco CISCO1941/K9 (revision 1.0) with 487424K/36864K bytes of memory. | |||
Processor board ID FCZ1727C5JE | |||
1 DSL controller | |||
1 Ethernet interface | |||
2 Gigabit Ethernet interfaces | |||
1 ATM interface | |||
3 terminal lines | |||
2 Cellular interfaces | |||
DRAM configuration is 64 bits wide with parity disabled. | |||
255K bytes of non-volatile configuration memory. | |||
250880K bytes of ATA System CompactFlash 0 (Read/Write) | |||
! initiate xDSL card, it's added automatically | |||
controller VDSL 0/1/0 | |||
==References== | ==References== |
Revision as of 10:12, 29 September 2013
Product codding
Cisco Multimode VDSL2 and ADSL2/2+ High-Speed WAN Interface Card
Product: EHWIC-VA-DSL-M Description: 1-port VDSL2/ADSL2+ EHWIC over POTS with Annex M Minimum IOS: 15.1(3)T VDSL2 (very high speed DSL) / Digital Subscriber Line / / EHWIC-VA-DSL-M \ \ \Annex M \ ADSL2/A2+ (asymmetric DSL) Enhanced High-Speed WAN Interface Card
LED explained
LED | Color | Description |
---|---|---|
EN | Green | Operating system is running. |
Amber | Interface card is resetting. | |
Blinking | System is initializing. | |
CD LED | Green | Lit when the unit is connected to the network and operating normally. On ADSL interface cards only, this LED blinks while training with DSLAMs. |
LP LED | Yellow | DSL interface is in loopback mode. |
Off | Normal operation. |
Config prep
! clean start by removing current config erase startup-config reload
Current platform info at the boot
Cisco CISCO1941/K9 (revision 1.0) with 487424K/36864K bytes of memory. Processor board ID FCZ1727C5JE 1 DSL controller 1 Ethernet interface 2 Gigabit Ethernet interfaces 1 ATM interface 3 terminal lines 2 Cellular interfaces DRAM configuration is 64 bits wide with parity disabled. 255K bytes of non-volatile configuration memory. 250880K bytes of ATA System CompactFlash 0 (Read/Write)
! initiate xDSL card, it's added automatically controller VDSL 0/1/0
References
- Cisco Multimode VDSL2 and ADSL2/2+ High-Speed WAN Interface Card
- Cisco Multimode VDSL2 and ADSL2/2+ EHWIC Q&A
- Connecting DSL WAN Interface Cards
- Overview of Cisco Interface Cards for Cisco Access Routers It explains EHWIC, HWIC, WIC cards differences
- Configuring PPP over ATM with NAT
- Basic Router Configuration